-
Телефон
0878 722 464
Най-продавани
-
3,00 лв. Цена
2024 Sparco Rush, картинг ръкавици
99,00 лв. Цена2025 Sparco K-Pole, картинг обувки
199,00 лв. Цена2025 Sparco Rookie, боне за картинг
19,00 лв. Цена
-
Подаръчен ваучер
25,00 лв. Цена2025 Speed Denver HS-2, картинг гащеризон
159,00 лв. ЦенаSpeed Dresden RK-1, предпазна кора
199,00 лв. Цена2025 Speed Melbourne G-2, картинг ръкавици
59,00 лв. Цена
2025 Aim EGT M5, температурен датчик отработени газове
Обадете ни се за бърза поръчка по телефона!
Ще съдействаме, за да изберете най-подходящата екипировка!
Защитено и лесно плащане!
Доставка на следващия ден за продукти на склад

Вземи желания продукт сега, избери подходяща за теб схема на изплащане:
Не е нужно да избираш, може да имаш всичко!
Купи на равни вноски стоки от 100 до 30000 лв., избери най-подходящата за теб вноска.
С TBI Pay, пазаруването е лесно, гъвкаво и напълно онлайн.
Контролът е в твоите ръце, не чакай.
Пазарувай!
Description
The sensor for measuring the Exhaust Gas Temperature (EGT) is mounted on the exhaust manifold near to the piston. The measurement and data plays a vital role in the adjustment of the kart carburetor, to have an efficient combustion and avoiding fatal engine damage.
Features
The AiM EGT sensor has a small sensor tip and uses the durable thermocouple principle. This ensures precise readings and the ability to trace rapid changes in the temperature.
Temperatures from 0 to 1000°C can be measured. The sensor has a compensated cable length of 250 mm.
Fits in a 5 mm thread.
Compatibility
MyChron5s & MyChron5s 2T
MyChron5 & MyChron5 2T
MyChron4 & MyChron4 2T
MyChron3 and earlier
Other lap timers may also use the sensor if they have the yellow plug.
12 други продукта в същата категория
2025 Aim MyChron6 2T, GPS времеизмерване
2025 Aim Кабел за обороти
2025 Aim MyChron6, GPS времеизмерване
2025 Aim M10x1, температурен датчик вода
2025 Aim EGT T12, температурен датчик отработени газове
2025 Aim M10 термо двойка
AiM devices can measure the water temperature using a sensor – thermocouple – placed in the
cooling system.
Datasheet can be downloaded here
Race Studio3 configuration can be downloaded here
Installation notes
The thermocouple has to be placed in the cooling system.
We suggest to install the sensor far from heat and electromagnetic interference sources (like RPM
cable or lap receiver cables).